http://www.brewershilllifestyle.com/beer-line-disconnect/
No flow from keg?
I have cleaned and sanitized the keg. I attached the ball lock disconnects. They seem to grip loosely “wiggle back and forth” but do not attach any more snugly to the ports. Are they attached properly? If I push down any more, they do not want to attach tighter. I attached Grey (gas) for IN and Black (beer) for OUT. I opened the gas out stem on the regulator (red handle), opened CO2 tank valve, open screw fully. CO2 tank gauge reads about 900 and holds steady. Adjust pressure screw to 5psi (holds steady). Spray hose connections with soapy solution, no leaks. Depress tap, NO FLOW. Currently there is sanitizing solution in the keg. I want to run it through the beverage line to sanitze, but NO FLOW. When I pull the quick release ring on the keg, there is no hiss. Does that mean there is no CO2 getting into the keg? If so, why am I getting steady readings on my gauges and no leaks with the soapy water test? How do I remedy this? What is the correct way to attach ball lock disconnects?
Try this site http://www.micromatic.com/forum/us-en/alltopics.php
How to build a Kegerator / Beer Fridge
|
|
5/16 Gas Line Assembly – Ball Lock $9.99 The 5/16″ Gas Line Assembly includes a ball lock gas in quick disconnect, 3 feet of 5/16″ tubing, and two hose clamps. Clamp the open end to the gas-out of your regulator or CO2 manifold, hook up the ball lock fitting to your Cornelius keg, and you’re ready to pressurize kegs…. |
|
|
Quick Disconnects for 3/16 Beer Line: Set of 1 Male and 1 Female $17.50 Add these quick disconnects to your beer lines and make it easier than ever to swap out couplers and other beer and air side accessories. Made of plastic and NSF approved, these quick disconnect beer fittings make an audible clicking noise, so you know when your lines are connected. You can purchase individual male and female couplings, or buy the set and get one of each! It’s recommended that qui… |
|
|
Quick Disconnects for 3/16 Beer Line: MALE Add these quick disconnects to your beer lines and make it easier than ever to swap out couplers and other beer and air side accessories. Made of plastic and NSF approved, these quick disconnect beer fittings make an audible clicking noise, so you know when your lines are connected. You can purchase individual male and female couplings, or buy the set and get one of each! It’s recommended that qui… |